Addressable Fire Alarm System Repeater
Introduction:
Fire alarml addressable repeat is a kind of microprocessor -controlled fire display panel developed by our company. Each fire alarm addressable repeater is connected to a fire alarm control panel produced by our company via a special RS-485 interface to process and display the data sent from the fire alarm control panel. Each floor of a building may have a repeterl installed. When there is a fire alarm on the floor where the repeater is installed, or the neighboring floor above or below it, the repeater will give a horn/strobe alarm and display the floor No., the room No., and some other position information of the fire alarm.
Parameters:
1. Executive standard: General Technical Conditions for Fire Indicating Panels (GB17429-1998)
2. Display capacity: Each display panel can display the fire alarm messages of floors -10~90 and at most 99 fire alarm messages or feedback messages.
3. Wiring system: Four-wire system, power lines (+24V, GND) and RS485 signal lines (485A, 485B)
4. Operating environment: Indoor; temperature: -10°C~+50°C; relative humidity: ≤95% (40°C, without condensation)
5. Power supply: DC 24V ±20 %
6. Overall power consumption: <3W
7. Contact capacity: Relay dry contacts, normally open or normally closed, capacity: 1.25A/DC30V (resistive load)